Step 7: Select relevant locations for further analyses
After analysing the results, you can select the relevant locations that you want to keep for the next steps by checking the box on the left of the location.
If you then go to the Map section you will see those selected locations highlighted in purple. Below the 'Map', you will also see a message 'Selected X items', indicating how many locations were highlighted. Please keep in mind that when you refresh the page, the selection will be gone. Highlighting allows you to manually make a selection of top expansion opportunities.
You can also highlight individual locations in the map section. Press on the location you want to highlight and select Selecting this option allows you to highlight this location on the map in purple. This will not only highlight it on the map, but it will also select the location in the table section. If you want to remove the highlight, you can select .
In the 'Table section you can then create a simulation of these selection to run it in 'Location Planning':
You can also delete those selected locations in bulk or reset selection:
Remarks:
If a location with multiple configurations has been tested in 1 batch run, the table allows you to retain the one with the best predicted result per charging point (taking into account the installation cost of the station with regards to the number of charging points).
To do this, simply drag the location name to the top of the table and check the consumption per charging point per location.
